Whirlpool Baths | Whirlpool Bath Spares | Whirlpool Bath Wastes & Fillers | Waterfall Bath Filler
OUT OF STOCK
This low profile waterfall bath filler can be mounted into the side of any bath and used to take either a mixed supply of water or separate hot and cold supplies to the two 15mm male connections. A flat surface of at least 135mm x 25mm is required.
This product is also available with an additional slot for connection to an overflow.
(You have 20mm diameter on the threads. This would be to take 15mm pipework and would broadly be identified as a half inch/15mm connection).
The products linked to this should be the shower controls with diverters and the new range of diverters - we could also link this to the shower controls. - We probably need a section for shower/bath fill valves called "mixer valves" - mixer valves can be thermostatic or just mixer valves, they can be for one item such as an overhead or hand shower or a bath fill. I think wall mounted is the way to go.
Measurements:Face Plate Length: 170mmFace Plate Height: 24mmOverall Depth: 48.5mmOutlet Length: 135mmOutlet Width: 2mmInlet/s Thread Diameter: 20mmInlet/s Thread Length: 10mm
Please Note: The image/s representing the product/s you are purchasing may appear aesthetically slightly different from the actual product. This may be due to necessary upgrades or minor changes for that model. If you have any doubts about what you are ordering, please give us a call on: 01633 244555
© Pegasus Whirlpool Baths Ltd Pegasus Whirlpool Baths Ltd :: 61-62 Lower Dock Street, Newport. NP201EF :: Registered in Cardiff No. 4289725
© Pegasus Whirlpool Baths Ltd Registered in Cardiff No. 4289725