Whirlpool Baths | Whirlpool Bath Spares | Whirlpool Bath Wastes & Fillers | Adjusting Screw and nut for Pegasus H1/W1 Whirlpool Pop-up-waste
OUT OF STOCK
Replacement screw for Pegasus pop up waste plug. The common symptom is that when you turn the handwheel to raise the plug and empty the bath, the plug doesn't raise. The loss of the adjustment screw is usually due to the installer not tightening up the nut at the time of installation.
To set the screw at the correct depth, Close the waste and simply screw the screw in until the plug rests on the drain collar without allowing water to pass.
Please Note: The image/s representing the product/s you are purchasing may appear aesthetically slightly different from the actual product. This may be due to necessary upgrades or minor changes for that model. If you have any doubts about what you are ordering, please give us a call on: 01633 244555
© Pegasus Whirlpool Baths Ltd Pegasus Whirlpool Baths Ltd :: 61-62 Lower Dock Street, Newport. NP201EF :: Registered in Cardiff No. 4289725
© Pegasus Whirlpool Baths Ltd Registered in Cardiff No. 4289725