This Astra Evolux 1.2hp whirlpool pump has imperial pump connections, pneumatic Switch and a connection for whirlpool system drain which can be connected into the Pegasus pop-up-waste with system drain connection as fitted to Pegasus Whirlpool Baths™.

The system drain is for 10mm OD nylon pipe, ff your existing pump has a drain of a different size, please contact us so that we can provide an additional adaptor - - if you don't require a drain, we will fit a stop plug in its place.

This whirlpool bath pump incorporates a pneumatic switch which can be used to turn the pump on and off. If your whirlpool bath has electronic controls and you don't need the pneumatic switch, it can simply be left in the 'on' position

This pump gives a genuine output of 1.2HP as stated on the 'P2' (output) rating. This should not be confused with other whirlpool bath pump suppliers who quote the 'P1' rating which is the input power - The input rating (P1) will always be higher than the out put rating (P2)

P1 1.30Kw / 1.75HP

P2 0.90kw / 1.20HP

230v 50hz - 6.5 amps

Dimensions: Length = 344mm, Height = 190mm, Width = 155mm

Pump housing: Polypropylene, Motor racket: Noryl/Ryton - Aluminium, Impeller: Noryl, Mechanical seal: Alumina / carbon graphite

If you have any doubt about the thread size of your whirlpool pump connections please Click here to determine if the pump you need is Imperial or Metric.